SYNOPSYS光学设计软件|ASAP光学设计软件|SOLIDWORKS 三维建模设计软件|RP Fiber Power仿真设计软件|武汉墨光科技有限公司

解决方案

SYNOPSYS™15.98 版本发布

The update to version 15.98 incorporates the following changes:

Features:

ARGLASS now accepts an argument NRM, which will defeat the error message that is shown when the index range of a material does not cover that in the lens. Normally this is a good check, but when matching plastics with the U catalog, if the range is only slightly out, the error is of no concern — and is displayed by every core in multicore mode, which is not friendly.

2. The MRG dialog now has a button to include the NRM argument in the MACro that gets run.

Bugs Fixed:

1. ZSEARCH did not get the final lens back if running in only CORE 0.

2. The worst case from MC was only saved by CORE 0.

3. BTOL did not calculate the tolerance on VNUM in some cases

4. The WAP 2 option did not calculate the entrance pupil correctly if there was a large amount of coma of the pupil and the search found ray failures.

5. The PAD SCAN button, if clicked while a previous scan was running, would alter the value of YP0 in the lens.